Skip to main content
Grimm OffRoad

Initial Release

Major VersionM

by AJ Smith

Introduction

This guide will walk through the correct installation procedure for the Grimm OffRoad F150/Raptor Hood Hinge Light Brackets.

Consumer Warning

All Grimm OffRoad products must be installed by a competent and qualified individual in accordance with the installation instructions intended for the product. Incorrectly installed products will void any warranties and may result in damage to the product or damage to the vehicle it was installed on. Read any provided instructions or guides and watch any available videos before attempting installation. If there are any questions, please contact Grimm OffRoad before starting installation.

Many products require the vehicle be properly raised and supported off the ground. The installer is responsible for confirming that this may be done in a safe manner and the correct equipment is available to perform the installation. Grimm OffRoad installation instructions assume the installer is able to properly and safely lift the vehicle.

Vehicles that have been modified will not perform the same as a stock vehicle. It is incumbent upon the owner of the vehicle to be aware of the differences the modifications will make to the driving characteristics of the vehicle. These may include (but are not limited to): changes in handling, braking, rollover angle, incompatibilities with the factory anti-lock braking systems, stability control systems, or traction control systems.

Notes

  • These light brackets are designed to be used with pod lights up to 3” in diameter.
  1. Verify that all parts shown in the picture are present.
    • Verify that all parts shown in the picture are present.

  2. Perform the installation of the brackets one side at a time. Using a 10mm socket, remove both hood hinge bolts on one side of the vehicle.
    • Perform the installation of the brackets one side at a time.

    • Using a 10mm socket, remove both hood hinge bolts on one side of the vehicle.

  3. There is a left and right hood hinge light bracket. Make sure you have the correct bracket for the side you are installing. The vertical part of the bracket is towards the center of the vehicle, the tabs face outward. Set the light bracket on top of the hood hinge and re-install the factory hardware.
    • There is a left and right hood hinge light bracket. Make sure you have the correct bracket for the side you are installing. The vertical part of the bracket is towards the center of the vehicle, the tabs face outward.

    • Set the light bracket on top of the hood hinge and re-install the factory hardware.

    • Take care to make sure the hood hinge location did not move. It is recommended to slowly close the hood to verify it still lines up correctly. Adjust if necessary.

    • Torque hardware to 9 lb-ft [12Nm].

  4. Repeat steps 2 and 3 for the other side.
    • Repeat steps 2 and 3 for the other side.

    • Install lights onto the light brackets per the light manufacturer's instructions.

Conclusion

Installation is Complete!

One other person completed this guide.

Chris

Member since: 07/01/2020

142 Reputation

31 Guides authored

Team

Chris and AJ Member of Chris and AJ

2 Members

58 Guides authored

0 Comments

Add Comment